Having a Mod Problem.

I have a mod thats giving me trouble. Briefly, it's firing on its own sometimes. I have to take the batteries out to stop it. Eventually after a day I can reinsert batteries and it will last a day or two. My question is is this common and does anyone know where I can get this mod serviced? Thanks

 

What mod is it?

 

It's not a commercial mod. It's a homemade VV box that someone gave me.

 

it will probably cost more to have it fixed then it is worth ? i'd suggest heading over to madvapes and search there,,they have cheap box mods FV and VV pre-built and build yourself

 

Probably just need to replace the switch. I bet [MENTION=6674]xxDznutzxx[/MENTION] would know, hopefully he will be by shortly to help you out.

 

it could be something faulty or it could just be a little juice got in the button causing it to stick. a picture would help immensely.

 

I agree, it sounds like either the switch is bad, or that it's grounding out from a short somewhere after the atty connector. I wouldn't recommend using it or putting batteries in it until it's repaired or replaced. Is it Variable Voltage, or regulated to a certain voltage? That could mean, albeit unlikely, a bad or shorted regulator or pot, but I don't think that would be a rogue firing issue, that more likely would be a meltdown issue.

 

Thank you for the info guys. I will post pics as soon as I get home.

 

Sounds like a stuck/faulty switch to me as well.

It could also be a shorted wire(s) touching around the switch or chip, look for loose wires as well.

 

浏览附件6564 Picture of the inside

 

[video=youtube;ugQhcRoDrKE]http://www.youtube.com/watch?v=ugQhcRoDrKE&feature=youtu.be[/video]

 

Any idea what regulator is in that mod? Could be as simple as bad resistor or as complicated as the regulator.

 

I have no idea. It was given to me.

 

Hey AZ that looks like a MV VV kit, I myself have never made one of those kits.

I wonder if in fact some of that hot glue dripped into the back of the switch when vaping and dried holding the back plate down.

To me it still looks like there is a short and some where the positive is making contact.

To be real if it was me, i would get as many parts out of that and just redo the whole thing. You could always try and pry the glue out and test each part as you enter to see where the failure happened. Here is a link to the kit MV VV kit .

 

Yeah, after starring at it for awhile I see the regulator under the voltage display. I suspect it is the resistor that connects to the control pin is bad or solder came loose

 

You guys are great trouble shooters Kalamazoo Vapor has a Fix my Mod at his web site I believe it said 14.99 plus shipping Boy Id be up a creek with no Paddle so I'm happy to see the vendors offering to Fix my Mod........

 

Anyone know if there is a site out there that sells magnets for the door?

 

would something like this work?

Rare Earth Magnets - 10 Piece Rare Earth Magnet Set

 

Start here, it's the easiest.



Either unscrew or snip the wire at the RED arrow. Pop in your batteries and see if it remains off. If it does then touch the snipped wire to to where the BLUE arrow is and see if it fires. Do it a few times. That should tell you if there is a problem with the switch which shouldn't be too hard to ungoop and replace.

FWIW any time you see hot melt like that = hack modder. I also like how that hot running reg has been insulated with goop too.

 

Nice I just learned a useful tid bit of repair work .